Descargar Imprimir esta página

Electronic Ignition System; Wiring Diagram - Husqvarna SM 610 Manual De Oficina

Ocultar thumbs Ver también para SM 610:

Publicidad

IMPIANTO ELETTRICO, STRUMENTO DIGITALE, IMPIANTO INIEZIONE CARBURANTE
ELCTRIC SYSTEM, DIGITAL INSTRUMENT, FUEL INJECTION SYSTEM
INSTALLATION ÉLECTRIQUE, INSTRUMENT DIGITAL, SYSTÈME DE INJECTION CARBURANT
ELEKTRISCHE ANLAGE, DIGITAL INSTRUMENTE, EINSPRITZUNG ANLAGE
SISTEMA ELÉCTRICO, INSTRUMENTO DIGITAL, SISTEMA INYECCIÓN GASOLINA

ELECTRONIC IGNITION SYSTEM

The ignition system is controlled by the ECU. The system belongs to the category of the integrated systems of digital electronic ignition with
advance and static distribution and gasoline electronic injection of intermittent sequential balanced type. This ignition system consists of a sensor
of the crankshaft position (Pick-up), an ECU, an ignition coil and an air pressure sensor of the intake manifold. The feeding of the ignition coil is
supplied by the battery with a power relay and is controlled by the ECU. The synchronization of the ignition is checked with precision with regard
to the engine r.p.m. and the position of the throttle control. Besides this basic condition, also the temperature and air pressure sensors and the
coolant temperature influence the synchronization of the ignition.
- Electronic power unit (1) (ECU)
- W.T.S. (3) (Water Temperature Sensor)
- Ignition coil (4)
- Fuel pump (5)
- Clutch switch (6)
- Ignition switch (8)
- O2 sensor heater (9)
- Battery (15)
- Electric start remote control switch (16)
- Starting motor (17)
- Voltage regulator-rectifier (18)
- Alternator (19)
- Gear shift position sensor (20)
- M.A.Q.S. (21) (pressure sensor+TPS sensor+air temperature sensor)
- Power relay (22)
- Fuse (23)
- R.H. switch (25)
- Injector (26)

WIRING DIAGRAM

(for the key to electrical cables, see page M.7)
Part. N. 8000 A7918 (02-2007)
M.22

Publicidad

loading

Este manual también es adecuado para:

Te 610 i.e.