Yamaha WaveRunner FX140 Manual De Servicio página 634

HULL
HOOD
HANDLEBAR
3. Install:
• Throttle cable
NOTE:
Fit the seal into the groove in the bracket.
4. Adjust:
• QSTS cable length a
QSTS cable length:
72 ± 0.5 mm (2.83 ± 0.02 in)
NOTE:
• Before adjusting the QSTS cables, set the
trim grip to the neutral position.
• Adjust the QSTS cable lengths a to the
specified length and be sure to take up any
slack.
5. Install:
• Handlebar cover 1
NOTE:
When the handlebar cover is in contact with
the steering boss cover, adjust the handlebar
mount angle so that the clearance a and b
are equal.
6. Adjust:
• Throttle cable free play
Refer to "CONTROL SYSTEM" in Chap-
ter 3.
7. Adjust:
• QSTS cable
Refer to "CONTROL SYSTEM" in Chap-
ter 3.
8-7
E