Siemens SINAMICS S120 Manual De Listas página 2523

<2> <3>
p0840[C] (0)
OFF2 S_src 1 (electrical)
<3>
p0844[C]
(1)
&
p0845[C]
(1)
OFF2 S_src 2 (electrical)
p0852[C] (1)
<3>
p3532[C] (0)
p3533[C] (0)
p0854[C] (0)
<3>
<1> STW1.10 must be set to ensure that the drive object accepts
the process data (PZD).
<2> PROFIdrive interconnection:
For the manufacturer-specific PROFIdrive telegram, the
upper input is connected to PROFIdrive signal E_STW1
([2447]). This only involves CDS0.
<3> Is predefined via the PC if the master control is retrieved.
1 2
DO: A_INF
Active Infeed - Control word, sequence control, infeed
Bit No. Control word sequence control infeed
= ON (close precharging/line contactor, pulses can be enabled)
0
0 = OFF1 (reduce Vdc along a ramp, pulse suppression and open precharging/line contactor)
1 = Operating condition no OFF2 (enable is possible)
1 0 = OFF2 (immediate pulse suppression, open precharging/line contactor and switching on
inhibited)
2 Reserved
1 = Enable operation (pulses can be enabled)
3
0 = Inhibit operation (suppress pulses)
4 Reserved
5 1 = Inhibit motoring operation
6 1 = Inhibit regenerative operation
7 Reserved
8 Reserved
9 Reserved
10 1 = Control by PLC <1>
11 Reserved
12 Reserved
13 Reserved
14 Reserved
15 Reserved
3 4 5 6
Function diagram
fp_8920_55_eng.vsd
SINAMICS S120/S150
09.11.18 V05.02.03
p0115[3]
STW seq_ctrl INF
r0898
r0898.0 To the sequencer [8932]
r0898.1 To the sequencer [8932]
r0898.3 To the sequencer [8932]
r0898.5
r0898.6
r0898.10
7 8
- 8920 -