Weighing (T+A)
Press to start sample container taring which is next followed automatically by sample
weighing (non-separable operations).
Weighing B
Press to start weighing final mass. The button is enabled only for a series containing
samples for which weighing A has been carried out. If there are no such samples,
the operation is disabled.
Weighing A
•
Upon pressing Weighing A button, the balance
searches samples list in order to find the first
sample for which weighing <A> is still to be
carried out. If there are no such samples the
balance displays a message informing you that
the operation is disabled.
•
•
If the operation is enabled then new data on
initiated process is displayed in the grey
workspace.
•
You are guided through the process by means of
prompts visible either in the workspace or bottom
bar.
•
•
Load the weighing pan with a sample and press <
> button.
•
For <Ambient condition> parameter set to
<Value>
option,
temperature and humidity values is displayed.
For <Ambient condition> parameter set to
<ONLINE> option, a window for confirmation of
values taken from ambient conditions module is
displayed.
Caution! If <Ambient conditions> parameter for the
differential weighing mode is set to <No> value, the
software skips this part of the process.
•
Press
<
conditions values, differential weighing home
screen is displayed, you are prompted to unload
the weighing pan.
•
Unload the weighing pan and press <
in order to find the first sample for which weighing <A> is still to be carried out. Follow the
above procedure and carry out weighing of the remaining samples.
a
window
>
button
to
confirm
for
entering
ambient
> button. The balance searches samples list again
- 111 -