Annex D - Zebra Printer Setting; Annex E - Barcode Scanner Settings - RADWAG 4Y Serie Manual Del Usuario

Formulations
Formulation with multiplier
Formulation with target mass
Formulation using out-of-database
ingredients
Formulation: Skip ingredient
Confirm
Abort
45.

ANNEX D - ZEBRA Printer Setting

Baud rate
Parity control
Bits
Stop bits
Information regarding RS 232, printed on a printout
Serial port: 96, N, 8, 1
Procedure for printing information printout and resetting printer parameters is to be found in ZEBRA
printer manual.
46.

ANNEX E - Barcode Scanner Settings

1. For communication with barcode scanners, RADWAG balances use RS232 interfaces and
simplex transmission (one-way direction), without handshaking. For this purpose, use of second
line of the cable is sufficient. Used scanners should be equipped with RS232 interface, both
hardware and software handshaking must be disabled.
2. Transmission parameters can be set for both weighing devices and scanners. For both devices
the following parameters must comply: baud rate, data bits quantity, parity control, stop bits
quantity: e.g. 9600,8,N,1 – baud rate 9600 bit/s, data 8-bits, no parity control, 1 stop bit.
3. Barcode scanners can send additional information apart from the expected barcode; e.g.
symbology (type of barcode). Due to the fact that RADWAG devices and software do not use
such information, it is advisable to disable it.
4. Some RADWAG systems can omit unnecessary information by using parameters that mark the
beginning and the length of the code required to analysis.
9600 b/sec
none
8 bit
1 bit
Moisture analyzer: Sample description
PGC: Ongoing control information
PGC: Control graph
Running working mode
Operators
Open/close left door
- 214 -