RADWAG 4Y Serie Manual Del Usuario página 128

Ultaramicrobalanza. microbalanza. microbalanzas para pipetas. microbalanzas para los filtros. balanzas analíticas. balanzas analíticas para los filtros
Ocultar thumbs Ver también para 4Y Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

-
-
-
Caution!
If a product is to be controlled by "Non-destructive average tare" mode, then accordingly to Regulation,
standard deviation "S" for its packaging mass, based on at least 10 measurements, cannot be lower than
0.1 and greater than 0.25 of maximum permissible negative error T, for nominal packaging mass. The
range is set independently for each product in products database.
After the last packaging mass measurement has been performed, the following message is
displayed:
Press
packaging mass to product data.
Press
mass to product data.
Measurements results are analysed continuously during control and displayed in respective fields :
Where:
Bar Graph
Display of graph.
Graph concerns control of mass only, while estimating average tare value,
the preview of packaging mass distribution is not possible.
Information on control
Abort control process
button to proceed to control without saving the newly estimated average
button to proceed to control with saving the newly estimated average packaging
-
Information
green bar graph – mass within tolerance range: between [-T] and
[+T] of net weight.
yellow bar graph – mass within tolerance range: between [-T] and [-
2T]
red bar graph – mass below net mass [NET – 2T].
on
product
net
weight
of
- 128 -
in
a
form
of
net
graph:
weight.

Publicidad

Tabla de contenido
loading

Tabla de contenido