Connectors Arrangement; Intended Use; Precautions - RADWAG 4Y Serie Manual Del Usuario

1.2. Connectors Arrangement

1 – Ethernet RJ45 connector
2 – RS232 (COM1) connector
3 – USB connector
Caution! 'Ethernet' – 'weighing device' cable is a standard network cable terminated with RJ45
connectors on both ends.

1.3. Intended Use

4Y series balances have been designed to enable precise determination of mass in laboratory.

1.4. Precautions

1. Prior the first use, carefully read the user manual. Use the device only as intended.
2. Do not operate the touch panel using sharp-edged tools (knife, screwdriver, etc.).
3. Place weighed loads in the centre of the weighing pan.
4. Load the weighing pan with loads of gross weight which does not exceed the maximum capacity.
5. Mind not to leave heavy loads on the weighing pan for longer periods of time.
6. In case of damage, immediately unplug the balance from the mains.
7. Balance to be decommissioned must be decommissioned in accordance with valid legal
regulations.
4 – I/O, RS232 (COM2) connector
- 17 -
balance – computer
cable (RS232)
balance – printer
cable (EPSON)
I/O cable