RADWAG 4Y Serie Manual Del Usuario página 27

Ultaramicrobalanza. microbalanza. microbalanzas para pipetas. microbalanzas para los filtros. balanzas analíticas. balanzas analíticas para los filtros
Ocultar thumbs Ver también para 4Y Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Cleaning Stainless Steel Components
When cleaning stainless steel components the following table should be followed, which lists the
types of contamination and ways of removing it.
Fingerprints
Oils, fats, greases
Temperature
stains
and discolorations
Strong discoloration
Traces of rust
Paints
Scratches
on
the
surface
Cleaning ABS Components
To clean dry surfaces and avoid smudging, use clean non-colouring cloths made of cellulose or
cotton. You can use a solution of water and detergent (soap, dishwashing detergent, glass cleaner).
Gently rub the cleaned surface and let it dry. Repeat the cleaning process if needed.
In the case of hard to remove contamination, e.g.: residues of adhesive, rubber, resin, polyurethane
foam etc., you can use a special cleaning agents based on a mixture of aliphatic hydrocarbons that
do not dissolve plastics. Before using the cleanser for all surfaces we recommend carrying out tests.
Do not use cleansers containing abrasive substances.
Disassembly steps:
MYA Balance
Clean with alcohol or dilutant. Rinse with clean water and wipe dry.
Wash with organic solvents and then clean with warm water with soap
or mild detergent. Rinse with clean water and wipe dry.
Wash with a gentle abrasive cleaner, clean lightly according to the
direction of the surface structure. Rinse with clean water and wipe dry.
Clean lightly according to the direction of the surface structure.
Rinse with clean water and wipe dry.
Moisten with oxalic acid solution and leave for about 15-20 minutes,
then wash with warm water with soap or mild detergent. Rinse with
clean water and wipe dry.
Wash with paint solvent and then rinse with warm water with soap or
mild detergent. Rinse with clean water and wipe dry.
Gently polish the surface with a non-woven fabric (iron-free) according
to the direction of the surface structure. Wash with a gentle abrasive
cleaner. Rinse with clean water and wipe dry.
Open the chamber.
Carefully remove the weighing pan (2).
Remove the draft shield (3).
Undo draft shield sleeve (4).
Remove internal ring assembly (5).
Remove snap-in holder (6), lever it using
e.g. tweezers.
Close the chamber, press the clamp (8)
down and move the ring assembly (7) to
the front and up.
- 27 -

Publicidad

Tabla de contenido
loading

Tabla de contenido