Troubleshooting - ORSI Acrobat 4.4 Traducción De Las Instrucciones Originales

6.11 TROUBLESHOOTING

PROBLEMS
Strange noises coming from the machine.
Excessive vibrations.
Irregular cut.
Overheating straps of transmission
Usury rapid utensils
Jam at the position of a control lever
POSSIBLE CAUSES
Poor lubrication bearing rotor.
Low oil gearbox.
Wrong speed of the taking of strength of the car.
Foreign bodies wrapped to the rotor.
Wrong speed of the taking of strength of the tractor.
Excessive consumption and irregular tool.
Knives worn or broken.
Damaged or broken utensils.
Wrong sense of rotation.
Belts lens.
Wrong position of the support roller, wheel or skids.
Wrong speed of the taking of strength of the tractor.
Straps slow or too tight
Forward speed too high compared to the chopping material
Utensils that touch the ground
Wear cursor due to dirt or rust.
ENGLISH
REMEDY
Grease.
Top up.
To verify the speed of the taking of strength (540 or 1000 turns / min).
Remove the extraneous body.
To verify the speed of the taking of strength (540 or 1000 turns / min).
Replace tools including those opposed.
Replace tools including those opposed.
Replace tools including those opposed.
Reverse the direction.
Tighten the belts.
Verify the alignment of the roll of support of the wheels or of the sleighs.
To verify the speed of the taking of strength (540 or 1000 turns / min).
Check the belt tension
Reduce the speed of the tractor
Adjust cutting height by acting on the organs support the tractor
Replace.
Qualification
215