Tabla de contenido
Publicidad
PROBLEMS
For machines equipped with heat exchanger,
the fan does not work (the fan starts only
when the temperature reaches 45-50 ° C)
All the arms of the bush cutters do not move.
The accessory or terminal has stopped or
does not work properly.
You can not control a single movement.
You can not control a single movement in the
event of machine equipped with electrical
controls.
216
POSSIBLE CAUSES
Blown fuse
electric fan burned
Radiator bulb burned
Hydraulic distributor jammed.
Pressure relief valve jammed.
Pump
Taken the pressure relief valve.
Cable remote control broken.
Eye cursor broken.
Pressure relief valve jammed.
Position of the ignition key.
Position of the emergency button.
Fuse
cut wires
Switch contacts and manipulators defective.
ENGLISH
REMEDY
Replace.
Replace.
Check electrical wiring directly to the battery and replace the bulb.
To verify the operation of the distributor, act in the following way:
1) Make sure the hose from the pump is properly connected.
2) Disconnect the output pipe and check that the oil comes out with the
right intensity;
3) Replace the pipe.
Replace the maximum pressure control valve.
Replace
Put in neutral position the control lever of the terminal tool and only for the
cutting head or ditch cutter, let the engine turn in the opposite direction to
unlock the equipment. Return the direction correct and restart, if not relight,
call the service center.
Replace the cable.
Replace the cursor.
Replace the valve.
Check.
Check.
Check.
Check
Check.
Qualification
Publicidad
Tabla de contenido
