Nussbaum WAB 02 CCT Instrucciones De Uso página 68

If the lift still does not work without the bypass button, the second
level safety cutoff (PIK) has been triggered and needs to be reset.
After having the lift back in bottom position, this is done in the
following way:
- Pull Fuse Holder F6 on the electric panel next to the power
outlet out -> most of the red LEDs on the Plate/Lift Controller
PCB will be off.
- Keep the small black PIK Reset button depressed, that is
shown on the right bottom of the photograph. At the same time,
put fuse F6 back in.
The secondary safety cutoff should now be reset. You can tell by
the fact that the PIK LED, as encircled on the photograph, is
lighting.
68
PIK LED
PIK-
Reset button
29.10.08 AD G9001 N