SICE S 1000 Manual De Instrucciones página 158

9- Remove the bead pressing tool as well as the bead pressing tool clamps if used.
10-
Move the
position.
11- Move the tool holder head away from the work area by operating controls
Position the bead pressing tool in the correct
rest position so that it does not interfere with
the work area.
NOTE: If the tyre is particularly soft, the fi rst
bead can be mounted with the mounting tool
positioned on the lower trolley to the side of the
bead breaker disc.
- place the tool in the work position by pulling
out the specifi c knob (see Fig. 28a - 28b);
- operating the
tool in order to move it near the upper rim edge
(see Fig. 28c);
158
lever downwards to bring the lower bead breaker disc to the rest
CAUTION!
control, lift the mounting
28b
and
28a
28c
User manual S 1000
.