Publicidad
Idiomas disponibles
Idiomas disponibles
Avoid Personal Injury. The operator must read, understand and observe the fol-
lowing instructions:
1. Overinfl ated tyres can explode, producing hazardous fl ying debris which may cause
injury.
2. Tyres and rims that do not have the same diameter do not correspond. Do not at-
tempt to mount or infl ate tyres with rims that do not correspond. For example, never
mount a 16" tyre on a 16.5" rim, (or vice versa). It is very dangerous. Tyres and rims
that do not correspond could explode, causing accidents.
3. Never exceed the infl ation pressure for the tyre (as read on the pressure gauge)
indicated by the manufacturer on the side of the tyre itself.
4. Never place your head or any part of your body over a tyre during the infl ation
process or when attempting to seat beads.
This machine is not intended to be a restraining device for exploding tyres, tubes
or rims.
5. Always stand back from the tyre changer when infl ating, never lean over.
During this operation, noise levels assessed at 85 dB(A) may occur.
Therefore operators are advised to wear hearing protection devices.
PROCEDURE:
1. Check that both the upper and lower beads and the rim
bead seat have been lubricated adequately with suitable
grease for mounting.
2. Clamp the wheel (Fig. 51).
3. Remove the inner core of the valve, if not already re-
moved (Fig. 51a).
4. Press the
NOTE: If an automatic work procedure is in use, activating the
device automatically terminates the automatic procedure.
User manual S 1000
CAUTION
CAUTION!
button to activate the INFLATRON.
UK
51
51a
179
Publicidad
