Dentsply Sirona SmartLite Pro EndoActivator Manual De Instrucciones página 11

Indicator lights
ON/OFF button light
• Slowly flashing orange handpiece battery has low power and must be exchanged soon
• Fast flashing orange handpiece battery is empty and must be exchanged to continue
to operate
• Solid orange unit is in an overheating protection state and can't be operated until light
turns off.
Light adjacent charging port (
• Solid orange battery is charging
• Solid green battery is fully charged.
Audible signals
• One short beep: battery or attachment insertion into handpiece
• One beep: start of cycle, interrupt, every 30 seconds of usage, or end of cycle
• Two beeps: warning (i.e. attachment is not connected)
• Four beeps: overheating protection.
Signal Condition
Battery Insertion
Start Cycle
Second power level
Stop cycle manually
End of cycle
Warnings (i.e. attachment not connected)
Low battery
Empty battery
Overheating protection
3.1 Installation and charging
1. Insert battery pack into handpiece. Battery pack is pre-charged however, it may be
necessary to charge the battery before first use.
2. To recharge the battery:
• Connect charging base to USB mini connector.
• Make sure power socket used for power connector is accessible at all times in case of
necessary emergency disconnection.
• Insert the battery onto the charging base. The battery light will illuminate solid orange,
indicating battery is recharging and will show constant green when fully charged.
Note, the SmartLite Pro EndoActivator™ Complete Kit comes with two batteries. It is
recommended that the battery not being used is stored on the charging base so that it is fully
charged when needed.
3.2 Operation – EndoActivator Attachment Assembly
1. Attach the EndoActivator Attachment to the SmartLite Pro® handpiece by firmly pressing
attachment into handpiece opening while slightly rotating at the same moment.
2. Protect assembled handpiece and attachment from gross debris by applying a single-use
barrier sleeve.
NOTE: no light with battery on top indicates missing contact
EndoActivator Attachment
Beep
2x
4x
Signal LED
1x -
1x -
1x -
1x -
1x -
-
- blinking
- blinking fast
continuous
)
11