Descargar Imprimir esta página

Dentsply Sirona SmartLite Pro EndoActivator Manual De Instrucciones página 17

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 82
Packaging
No particular requirements.
Sterilization
• N/A
Sterilization is not allowed. No methods have been validated.
Do not subject components to steam autoclaving or liquid chemical sterilant immersion.
Component damage will occur.
Storage
Store the handpiece, attachment and charging base at room temperature, away from
moisture or excessive humidity.
Additional
Reassemble for use as described above in step-by-step instructions.
Information
Manufacturer
Within the United States, call Dentsply Sirona at 1-844-848-0137. For areas outside the
Contact
United States, contact your local Dentsply Sirona representative.
The instructions provided above have been validated by the manufacturer of the medical device as being capable of
preparing a medical device for reuse. It remains the responsibility of the processor to ensure that the processing, as
actually performed using equipment, materials and personnel in the processing facility, achieves the desired result. This
requires verification and/or validation and routine monitoring of the process.
Incidental surface contact of the power supply and cord with water, soap or a water-based
hospital-level disinfection solution will not damage the material of construction. Do not allow
any solution to penetrate the casing.
4.3 Disposal of Unit
This device is provided with a lithium-ion phosphate battery. Device and battery must not
be disposed of in normal domestic waste. For environmental reasons, dispose of device and
battery according to local environmental guidelines or regulations.
5. MAINTENANCE
5.1 Battery
• Batteries are equipped with low self-discharge technology resulting in a long operating life.
• Batteries are pre-charged and ready to use upon purchase, however, charging before the
first use is recommended.
• When the battery light shows solid orange the battery is charging. Upon complete
recharging, the battery light remains permanently green. The battery needs approximately 2
hours to be fully recharged.
• When the ON-OFF button light slowly flashes orange the battery needs to be recharged. At
first occurrence approximately 10-20 cycles remain. Sonic activation energy is not reduced
during this period.
• If the battery pack needs to be replaced, simply pull the battery pack by pulling it from the
main housing along its longitudinal axis.
5.2 General maintenance
• A thin coating of petroleum jelly may be applied to attachment o-rings and charging base
battery post as needed to facilitate insertion and removal.
• Inspect and replace worn or damaged o-rings as needed to maintain optimal performance.
6. REORDER INFORMATION, TECHNICAL DATA, WARRANTY TERMS,
CORRESPONDENCE
6.1 Accessories
Accessory
SmartLite Pro EndoActivator™ Barrier Sleeves
SmartLite Pro EndoActivator™ Activator Tips - Small (25/pack)
SmartLite Pro EndoActivator™ Activator Tips - Medium (25/pack)
SmartLite Pro EndoActivator™ Activator Tips - Medium Long (25/pack)
SmartLite Pro EndoActivator™ Attachment
SmartLite Pro® Battery
SmartLite Pro® O-Rings (3/pack)
Reorder no.
644434
644435
644436
644437
644438
644401
644408
17

Publicidad

loading