EXFO FTB-8510B Guia Del Usuario página 1206

Automatic Power Failure Recovery
Manual Power Failure Recovery
If only the requirement number 1 is met, the saved configuration will be
loaded when the FTB-8100 Series is manually started from ToolBox. Thus,
the test that was running will be re-created, configured, and restarted.
Note: The power failure recovery is disabled when the GUI terminates normally
or when the test case is cleared.
When Using the Test Timer
Refer to Timer Configuration on page 130 for more information on test
timer.
The test that was running will be re-created and started after a power
failure if all the following conditions are met:
The test was running.
Startup Application is enabled on the FTB-500.
The start time has not expired during the power failure.
The stop time or the duration has not expired during the power failure.
When Using SmartMode
SmartMode is not supported meaning that SmartMode will return to its
default factory settings after a power failure recovery.
556
FTB-8100 Series Transport Blazer