Lop Oh Tx/Rx (Sdh) - EXFO FTB-8510B Guia Del Usuario

SDH Tabs

LOP OH TX/RX (SDH)

LOP OH TX/RX (SDH)
The LOP OH TX allows changing the low order path transport overhead
information to be transmitted while the LOP OH RX allows verification of
the low order path transport overhead information received.
Note: See LOP OH TX/RX (SDH, TU-3 path) on page 367 for TU-3 path test case.
Press TEST, LOP , and OH (under LOP TX/RX).
Path Overhead
Enter the path overhead values in hexadecimal or binary.
Binary allows either displaying all overhead values in binary (when
enabled) or hexadecimal (when disabled). This setting is disabled by
default.
V5 (VC Path Overhead)
J2 (Path Trace). J2 is only available when Enable Trace from the LOP
TX (SDH) on page 347 is disabled.
N2 (Network operator byte) Tandem Connection Monitoring
K4 (Extended signal label)
356
FTB-8100 Series Transport Blazer