16 Bert Tabs; Pattern Tx - EXFO FTB-8510B Guia Del Usuario

16 BERT Tabs

This section describes the BERT tabs.

Pattern TX

Pattern RX
Performance Monitoring (PM)
Client Offset TX
Client Offset RX
a. This tab is described in the Common Tabs section.
Pattern TX
Note: This tab is not used when Through mode is enabled.
Press TEST, and BERT.
Configuration
Overwrite: Available with SONET/SDH Intrusive through mode down
to HOP mapping level only; not supported with DSn/PDH, LOP , and
Next Generation mapping levels. Not available on FTB-8105/FTB-8115.
The Overwrite check box when selected, allows the termination of the
RX pattern and the insertion (TX) of the selected PRBS test pattern.
SONET/SDH Application
Tab
a
a
a
Page
405
409
504
513
515
405