Introducing The Test Setup - EXFO FTB-8510B Guia Del Usuario

Creating and Starting a Test Case

Introducing the Test Setup

Introducing the Test Setup
The Test Setup window allows the creation of the test case by navigating
through the signal structure. In the case where the GUI is not in the setup
window, select the Setup tab from the TEST Tab (refer to 30).
Data Path
Selector
Tree tab allows seeing the configuration test structure (data path).
Grid tab is used for timeslot selection or test case direction (decoupled
test mode).
Data Path Selector is used for the selection of each node (for
example: port, signal, tributary, VCG, GFP , Pattern) of the test case.
Configuration section allows parameters configuration for each node
of the test.
Test Name represents the name of the test. The default setting is TEST.
62
Configuration
section
Test Setup
Controls
FTB-8100 Series Transport Blazer