EXFO FTB-8510B Guia Del Usuario página 744

Creating and Starting a Test Case
Typical Test Cases
3. OTU Interface selection and configuration.
3a. Press OTU1 or OTU2. Choices depend on the
3b. For OTU2 interface with Unframed mode, press
3c. Select the Enable FEC and Enable Scrambler check boxes if
3d. Press Next.
4. Select ODU TCM (TCM1 to TCM6) layers as required.
4a. Press Next or Finish.
5. Select the test Path/Mapping:
5a. From the data path
94
rates available on the Transport Blazer module.
Next and go to step 6.
needed. Refer to FEC TX on page 154 and OTU TX on page 157 for
more information.
selector, select the
desired path/
mapping. Choices
depend on the
selected interface.
See Supported
Paths/Mappings on
page 59 for more
information.
FTB-8100 Series Transport Blazer