SONET Tabs
LOP OH TX/RX (SONET)
LOP OH TX/RX (SONET)
The LOP OH TX allows changing the low order path overhead information
to be transmitted while the LOP OH RX allows verification of the low order
path overhead information received.
Press TEST, LOP , and OH (under LOP TX/RX).
Path Overhead
Binary allows either displaying all overhead values in binary (when
enabled) or hexadecimal (when disabled). This setting is disabled by
default.
V5 (VT Path Overhead)
J2 (VT Path Trace). J2 is only available when Enable Trace from the
LOP TX (SONET) on page 257 is disabled.
Z6: VT Tandem Connection Monitoring
Z7: Extended signal label
266
FTB-8100 Series Transport Blazer