Gfp Client Rx - EXFO FTB-8510B Guia Del Usuario

GFP Client RX

Note: This tab is only available when using External Ethernet.
Press TEST, GFP , and Client (under GFP RX).
External Configuration
Note: External Configuration parameters for both GFP Client TX and RX tabs are
coupled.
Interface allows the Ethernet interface type selection. Choices are
Electrical and Optical. The default setting is Electrical unless
otherwise set during the test setup.
Note: Selecting the optical interface automatically turn the interface laser On. To
turn it off, select the electrical interface.
Rate allows the interface rate selection. Choices are 1000BaseT Full
Duplex, 100BaseT Full Duplex, and 10BaseT Full Duplex for
electrical interface and, 1000BaseX Full-Duplex for optical interface.
The default setting is 1000BaseT Full Duplex for electrical interface
and 1000BaseX Full Duplex for optical interface.
Enable Auto-Negotiation: Allows the auto-negotiation of the port
speed when the rate is set to 100BaseT or 10BaseT. Auto-negotiation is
always enabled for 1000BaseT.
SONET/SDH Application
Next-Generation Tabs

GFP Client RX

457