Gfp Channel Rx - EXFO FTB-8510B Guia Del Usuario

GFP Channel RX

Press TEST, GFP , and Channel (under GFP RX).
Configuration
Client Data Frames FCS enables detecting the presence of the
expected payload FCS for the client frames. This setting is enabled by
default. Not supported with GFP-F over OPU2 and GFP-T over OPU0.
Client Management Frames FCS enables detecting the presence of
the expected payload FCS for the management frames. This setting is
disabled by default.
CID (Channel IDentifier) selects the communication channel used for
the signal reception. Choices are from 00000000 through 11111111 (0
to 255). Only available when EXI is set to Linear.
Note: The CID value is the same for both the Client Management and Data
Frames. CID is not available with GFP over OPU2.
Mismatch
PFI (Payload FCS Identifier): Indicates the number of frames with PFI
field not matching the expected PFI.
CID (Channel IDentifier): Indicates the number of frames CID field not
matching the expected CID. Only available when EXI is set to Linear.
SONET/SDH Application
Next-Generation Tabs

GFP Channel RX

451