EXFO FTB-8510B Guia Del Usuario página 734

Creating and Starting a Test Case
Typical Test Cases
2. Interface connector selection:
2a. From the data path
2b. For OC-192/STM-64 select Framed or
2c. For Decoupled test
2d. Press Next.
3. Interface selection:
3a. Press the desired interface: OC-3, OC-12, OC-48, OC-192, STM-1,
3b. Press Next. For OC-192/STM64 interface with Unframed mode, go
84
selector, press the
Optical interface connector. Optical is automatically selected
when SONET/SDH Intrusive check box is selected.
Unframed. Framed is automatically selected in
Through or decoupled mode. For all other
optical interfaces, select Framed.
mode, both TX and
RX ports have to be
selected and
configured:
First select the
interface type for
TX from the data
path selector then
proceed with the
rest of the test setup steps to set the test parameters for the TX
interface. At the end, do not press Finish yet. Press Back to return
to the RX/TX selection screen and select the interface type for RX
from the data path selector then proceed with the rest of the test
setup steps to set the test parameters for the RX interface.
STM-4, STM-16, STM-64. Choices depend on the rates available
on the FTB-8115/20/30 module.
to step 5.
FTB-8100 Series Transport Blazer