Client Offset Tx - EXFO FTB-8510B Guia Del Usuario

Client Offset TX

Note: Available with ODUflex CBR and Gb Ethernet client. Not available in
Through mode.
For ODUflex CBR, press TEST, BERT, and Client Offset.
For Gb Ethernet, press TEST, Gb Ethernet, and Client Offset.
Frequency
Frequency Offset (ppm): Allows entering a positive or a negative
client frequency offset in ppm. The default setting is 0.
On/Off button: Allows enabling the frequency offset generation. This
setting is disabled (Off) by default.
Actual Frequency (bps): Indicates the frequency (Nominal fequency
+ port frequency offset + client frequency offset) used for
transmission fo the client signal. Refer to Frequency on page 149 for the
port frequency offset.
SONET/SDH Application
Common Tabs
Client Offset TX
BERT
Gb Ethernet
513