Fdl Prm Tx - EXFO FTB-8510B Guia Del Usuario

DSn Tabs

FDL PRM TX

FDL PRM TX

Press TEST, DSn-PDH, and PRM (under DSn-PDH TX).
Note: FDL PRM TX is only available for DS1 interface with ESF framing when
Enable FDL from FDL TX/RX is enabled. For Dual RX test, FDL is only
available for the primary DS1 TX/RX port.
Performance Report Messages
Circuit allows the selection of the circuit type. Choices are CI to
Network and Network to CI. The default setting is CI to Network.
ANSI T1-403 allows the generation of a compliant ANSI T1.403 PRM
Message.
Manual
Send allows to manually send the selected PRM Message(s).
Continuous
On/Off allows to generate the selected PRM Message(s) continuously.
288
FTB-8100 Series Transport Blazer