2. Interface connector selection:
2a. From the data path
2b. Select Framed or Unframed. Framed is
2c. Press Next.
3. Interface selection and configuration:
3a. Press the desired interface: OTU1e (11.049G),
3b. When Unframed is selected, press Next and go to step 6.
3c. Select the Enable FEC and Enable Scrambler check boxes if
3d. Press Next.
4. Select ODU TCM (TCM1 to TCM6) layers as required
and press Next or Finish.
SONET/SDH Application
selector, press the
Optical interface connector. Optical is automatically selected
when OTN Intrusive check box is selected.
automatically selected in Through or
decoupled mode.
OTU2e (11.096G), OTU1f (11.270G) or
OTU2f (11.317G).
needed. Refer to FEC TX on page 154 and OTU TX on page 157 for
more information.
Creating and Starting a Test Case
Typical Test Cases
109