Clock Synchronization - EXFO FTB-8510B Guia Del Usuario

System Tab

Clock Synchronization

Clock Synchronization
Press System and Clock Synchronization.
Note: TX and RX clock configuration is not available when the test mode is set to
Dual RX. Refer to Test Configuration on page 126 for more information.
TX
Note: TX clock configuration is only possible when the RX clock is set to None.
Configuration: Allows the configuration of the clock that will be
generated. First select the Interface Type then, the other parameters will
become accessible for configuration.
Interface Type: Allows the selection of the clock interface signal
(DS1/E1/2M) that will be generated. Choices are: None, DS1, E1, and
2 MHz. The default setting is None.
520
FTB-8100 Series Transport Blazer