EXFO FTB-8510B Guia Del Usuario página 745

5b. For ODU1 and ODU0, select a tributary slot,
5c. For ODUflex, select the OPU2 tributary slots
5d. For OC-x and STM-x, press Next.
5e. For STS/VT/AU/TU mapping level, select the
5f. For GFP , the UPI and the EXI parameters are
5g. For 10G Ethernet, Gb Ethernet, or Ethernet in
5h. Press Next or Finish.
SONET/SDH Application
choices are:
For ODU1 in ODU2: 1 of 4 OPU2 tributary slots
For ODU0 in ODU2: 1 of 8 OPU2 tributary slots
For ODU0 in ODU1: 1 of 2 OPU1 tributary slots.
Select ODU TCM (TCM1 to TCM6) layers as
required. The Tributary Port associated to the
selected tributary slot is displayed.
(1 to 8), enable ODUflex TCM (TCM1 to TCM6)
layers as required, and select the Tributary Port
number (1 to 8) that will be associated to the
selected tributary slots. The current bandwith
and the number of selected tributary slots are
displayed.
timeslot and enable TCM when required.
preset and not configurable. GFP is available in
Coupled test mode only. Refer to GFP Frame TX
on page 432 for more information.
GFP , set the Ethernet parameters. Refer to
Configuration on page 393 for more information.
Creating and Starting a Test Case
Typical Test Cases
95