EXFO FTB-8510B Guia Del Usuario página 735

4. Select the test
Path/Mapping.
4a. From the Data Path
4b. From the data path
4c. Press a timeslot from the Grid tab when applicable.
4d. For STS/STM and VT/AU mapping level, select
4e. For DSn/PDH mapping level,
SONET/SDH Application
Selector, select
Normal.
selector, press the
desired path/
mapping. Choices
depend on the
selected interface.
See Supported
Paths/Mappings on
page 59 for more information.
the Enable TCM check box if needed.
select the Framing. For more
information, refer to DSn Tabs or
PDH Tabs.
For DS3, select the Enable FEAC
check box to allow far end alarm and control testing.
For DS1, select the Enable FDL check box to allow facility data
link testing.
For DS1/E1, select the Enable DS0/E0 check box to allow DS0 or
E0 testing.
Creating and Starting a Test Case
Typical Test Cases
85