EXFO FTB-8510B Guia Del Usuario página 756

Creating and Starting a Test Case
Typical Test Cases
4f. Configure the following VCG parameters:
4g. To add another timeslot to the VCG group:
4h. Repeat step 4g to add more timeslot to the LOP/HOP VCG group.
4i. Press Next or Finish.
106
Set the SQ and ExSQ number (when LCAS is
not enabled) or set the Auto Add at Startup
(when LCAS is enabled) for each timeslot
selected.
SQ: The SQ number of each member can be
changed when LCAS is not enabled. Press a
specific member SQ number and enter the new
number. Possible values are from 0 to 63.
ExSQ: The ExSQ number of each member can be changed when
LCAS is not enabled. Press a specific member ExSQ number and
enter the new number. Possible values are from 0 to 63.
Auto Add at Startup: Enables the selected member to be
automatically added (applied) when the test is started. The
activation can be done individually for the Source and Sink. Only
available when LCAS is enabled. This setting is disabled by default
unless otherwise set from either the Add Member(s) at Start on
page 105 or LCAS Auto-Add at Startup on page 542.
Group Size indicates the type and size of the VCG members as
well as the bandwidth used by the VCG group.
For LOP VCG-1, press Back, select another STS-1/AU timeslot,
press Next then press and configure (see step 4f) every LOP
timeslot that need to become VCG member of the selected
STS-1/AU timeslot
For HOP VCG-1, select another timeslot and configure its
parameters as described in the step 4f.
FTB-8100 Series Transport Blazer