EXFO FTB-8510B Guia Del Usuario página 723

4. For DS3, select the test
path/mapping.
4a. From the data path
4b. Select the Framing. For more
4c. For DS1, select the Enable FDL check
4d. For DS1, select the Enable DS0/E0 check box to allow DS0 or E0
4e. For Pattern, go to step 5.
4f. Press Next or Finish.
4g. Repeat step 4 as required to complete the path/mapping. See
5. Pattern Configuration:
5a. Set the pattern parameters. Refer to Pattern TX
SONET/SDH Application
selector, press the
desired mapping
then press the
timeslot from the
Grid tab. Choices
depend on the
selected interface.
See Supported
Paths/Mappings on
page 59 for more
information.
information, refer to DSn Tabs on
page 269.
box to allow facility data link testing.
FDL is only available for the main DS1 TX/RX port.
testing.
Supported Paths/Mappings on page 59 for more information.
on page 405 and Pattern RX on page 409 for
more information.
Creating and Starting a Test Case
Typical Test Cases
73