Ds0/64K Tx; Configuration - EXFO FTB-8510B Guia Del Usuario

DSn Tabs

DS0/64K TX

DS0/64K TX

Press TEST, DSn-PDH, and DS0 (under DSn-PDH TX).
Note: DS0/64K TX configuration is not available when the selected framing from
the DS1/1.5M TX on page 275 is unframed.

Configuration

Enable DS0: Allows the activation of DS0/64K testing. This setting is
disabled (Off) by default unless otherwise set during the test setup.
DS0 Mode: Allows the selection of the channel timeslot data rate for
the pattern payload content. Choices are 56K and 64K. The default
setting is 64K.
56K: A timeslot data rate of 56 Kbps uses 7 bits to carry the payload
information.
64K: A timeslot data rate of 64 Kbps uses 8 bits to carry the payload
information.
270
FTB-8100 Series Transport Blazer