Interface Configuration - EXFO FTB-8510B Guia Del Usuario

Creating and Starting a Test Case
Typical Test Cases

3. Interface configuration:

3a. From the Interface tab, select the Framing,
3b. From the Loopback tab, select
3c. For Manual:
3d. For Auto-Response:
76
Line Coding, and TX LBO.
The RX Termination Mode is set to Term.
For more information, refer to DS1/1.5M TX on
page 275 for the framing, Port TX (Electrical
Interfaces) on page 138 for Line Coding and
LBO, and to DS1/1.5M RX on page 278 for
Termination Mode.
Enable FDL check box is automatically
selected to allow facility data link testing.
the loopback control Mode:
Manual or Auto-Response.
Select the Type of loopback
code that will be applied:
None, Line, or Payload.
Payload is only available with
SF and ESF framings.
The Loopback Active LED
indicates the presence of an
active loopback.
Select the Type of loopback code on which the module will
respond: In-Band or Out-of-Band. Out-of-Band is only available
when the interface framing is set to ESF.
FTB-8100 Series Transport Blazer