EXFO FTB-8510B Guia Del Usuario página 722

Creating and Starting a Test Case
Typical Test Cases
3. Interface configuration:
3a. Select the Framing, Line Coding, TX
3b. Select the Termination Mode for both
3c. For DS1, select the Enable FDL check box to
3d. For DS1/E1, select the Enable DS0/E0 check
3e. For DS3 interface, select the Enable FEAC
3f. Press Next or Finish.
72
LBO, and RX Termination Mode. Term,
Mon, and Bridge (DS1 only) termination
modes are available. For more
information, refer to TX - DSn Tabs on
page 269 or PDH Tabs on page 369 for the
framing, Port TX (Electrical Interfaces) on
page 138 for Line Coding and LBO, or RX
DSn Tabs on page 269.
RX ports. Dual RX test case uses the BNC
labelled AUX for the second RX port.
allow facility data link testing.
box to allow DS0 or E0 testing.
check box to allow far end alarm and control
testing.
FTB-8100 Series Transport Blazer