Gfp Channel Tx - EXFO FTB-8510B Guia Del Usuario

GFP Channel TX

Press TEST, GFP , and Channel (under GFP TX).
Configuration
Client Data Frames FCS enables the presence of the payload FCS for
the client frames. This setting is enabled by default. Not supported with
GFP-F over OPU2 and GFP-T over OPU0.
Client Management Frames FCS enables the presence of the payload
FCS for the management frames. This setting is disabled by default.
CID (Channel IDentifier) selects the communication channel used for
the signal transmission. Choices are from 00000000 through 11111111
(0 to 255). The default value is 0 when EXI is set to Linear. CID not
available when EXI is set to Null (see GFP Frame TX on page 432).
Note: The CID value is the same for both the Client Management and Data
Frames. CID is not available with GFP over OPU2.
SONET/SDH Application
Next-Generation Tabs

GFP Channel TX

435