EXFO FTB-8510B Guia Del Usuario página 979

K1
K2
SONET/SDH Application
Request: Bits 1 through 4 of the K1 byte. The default setting is No
Request (0000). Refer to K1 on page 237 for available/possible
choices.
Channel ID/Destination Node ID: Bits 5 through 8 of the K1 byte.
Channel if available with Linear switching mode while Destination
Node ID is available with Ring switching mode. The default setting
is Null Channel for Linear switching mode and 0 for Ring
switching mode. Refer to Channel/Destination Node ID on
page 238 for available/possible choices.
Protected Channel/Source Node ID: Bits 1 through 4 of the K2
byte. Protected Channel is available with Linear switching mode
while Source Node ID is available with Ring switching mode. The
default setting is Null Channel for Linear switching mode and 0 for
Ring switching mode. Refer to K2 on page 239 for
available/possible choices.
Architecture/Bridge Request: Bit 5 of the K2 byte. Architecture is
available with Linear switching mode while Bridge Request is
available with Ring switching mode. The default setting is 1+1 for
Linear switching mode and Short Path Request for Ring
switching mode. Refer to K2 on page 239 for available/possible
choices.
Multiplex Section APS/Advanced OH TX/RX (SDH)
SDH Tabs
329