EXFO FTB-8510B Guia Del Usuario página 718

Creating and Starting a Test Case
Typical Test Cases
3. Interface selection and configuration:
3a. Press the desired
3b. Select the Framing, Line
3c. For DS1, select the Enable FDL check box to allow facility data
3d. For DS1/E1, select the Enable DS0/E0 check box to allow DS0 or
3e. For DS3 interface, select the Enable FEAC check box to allow far
3f. Press Next or Finish.
68
interface: DS3,
DS1, E4, E3, E2, or E1.
Coding, TX LBO (DSn interface
only), and RX Termination
Mode. Term, Mon, and Bridge
(DS1/E1 only) termination mode
are available. For more
information, refer to TX - DSn
Tabs on page 269 or PDH Tabs on
page 369 for the framing, Port TX
(Electrical Interfaces) on
page 138 for Line Coding and
LBO, to RX - DSn Tabs on page 269 or PDH Tabs on page 369 for
Termination Mode.
link testing.
E0 testing.
end alarm and control testing.
FTB-8100 Series Transport Blazer