EXFO FTB-8510B Guia Del Usuario página 721

Creating an Electrical DS1 or DS3 Test Case in Dual
RX Mode (FTB-8105/15/20/30)
The following procedures describe the creation of an electrical DS1 or DS3
test case in Dual RX mode.
To create an Electrical DS1 or DS3 Test in Dual RX mode:
1. Test configuration:
1a. Select the source Clock Mode that will be used
1b. Select Dual RX (DS1 or DS3 signals) as the Test
1c. Press Next.
2. Interface connector selection:
2a. From the data path selector, press the desired electrical interface
2b. Press Next.
SONET/SDH Application
for the test. Refer to Clock Configuration on
page 129 for more information.
Mode. Refer to Test Configuration on page 126
for more information.
The Coupled check box is automatically
selected for Dual RX mode meaning that the settings for both the
TX and RX signals are the same.
connector.
BNC for DS3, Bantam or RJ-48c for DS1.
Creating and Starting a Test Case
Typical Test Cases
71