Creating and Starting a Test Case
Typical Test Cases
4. Press Finish to complete the test setup.
The DS1 Loopback function is now operational; no need to start the
test. However, the test may be started to monitor the condition of the
DS1 line connection to that test equipment.
5. For additional configuration parameters and results, refer to Summary
Tabs on page 125, Port Tabs on page 137, and DSn Tabs on page 269.
6. For additional configuration parameters and results, refer to the
following chapters: Summary, Port, and DSn tabs.
7. Press the Start button to start the test. Refer to Global Test Status and
Controls on page 35 for more information on test management.
78
FTB-8100 Series Transport Blazer