EXFO FTB-8510B Guia Del Usuario página 738

Creating and Starting a Test Case
Typical Test Cases
2. Interface connector selection:
2a. The Optical port is automatically selected.
2b. For Decoupled test
2c. Press Next.
3.
Interface selection.
3a. Press the desired interface: OC-768, or STM-256.
3b. Press Next. When Unframed is selected, press Next and go to
88
Select Framed or Unframed. Framed is
automatically selected in Through or
decoupled mode.
For the FTB-8140-DPSK model, select the
wavelength and invert the polarity if required
(refer to Wavelength (nm) on page 148).
mode, both TX and
RX ports have to be
selected and
configured:
First select the
interface type for
TX from the data
path selector then
proceed with the
rest of the test setup steps to set the test parameters for the TX
interface. At the end, do not press Finish yet. Press Back to return
to the RX/TX selection screen and select the interface type for RX
from the data path selector then proceed with the rest of the test
setup steps to set the test parameters for the RX interface.
step 5.
FTB-8100 Series Transport Blazer