EXFO FTB-8510B Guia Del Usuario página 752

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Creating and Starting a Test Case
Typical Test Cases
5h. For 10G Ethernet, Gb Ethernet, and Ethernet
5i. Press Next or Finish.
6. Pattern Configuration:
6a. Set the pattern parameters. Refer to Pattern TX
7. Press Finish to complete the test setup. The Grid tab
closes and automatically switch to the Alarm summary tab.
8. For additional configuration parameters and results, refer to Summary
Tabs on page 125, Port Tabs on page 137, OTN Tabs on page 153,
SONET Tabs on page 211, SDH Tabs on page 303, BERT Tabs on
page 405, Advanced Tabs on page 411, and Common Tabs on
page 491. For Unframed mode, only Summary, Port, and BERT tabs
are available.
9. Press the Start button to start the test. Refer to Global Test Status and
Controls on page 35 for more information on test management.
102
in GFP, set the Ethernet parameters. Refer to
Configuration on page 393 for more
information.
on page 405 and Pattern RX on page 409 for
more information.
FTB-8100 Series Transport Blazer

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Ftb-8510gFtb-8525Ftb-8535Ftb-8120nceFtb-8103nce

Tabla de contenido