EXFO FTB-8510B Guia Del Usuario página 754

Creating and Starting a Test Case
Typical Test Cases
3. Interface selection.
3a. Press the desired interface: OC-3, OC-12, OC-48, OC-192, STM-1,
3b. Press Next.
4. Select the test Path/Mapping.
4a. From the data path
4b. Press the desired
104
STM-4, STM-16, STM-64, OTU1, or OTU2. However, for the OTU1
and OTU2 interfaces, OC-N/STM-N must be part of the test path
(refer to Creating an OTN (OTU1 and OTU2) Test Case). Choices
depend on the rates available on the module.
selector, select
LOP VCG-1 or
HOP VCG-1.
path/ mapping. See
Supported
Paths/Mappings on
page 59 for more
information.
For LOP VCG-1,
STS-1 is
automatically
selected for SONET and choices are AU-3 and AU-4 for SDH.
For HOP VCG-1, choices are STS-1-Xv and STS-3c-Xv for SONET,
VC-3-Xv and VC-4-Xv for SDH.
FTB-8100 Series Transport Blazer