EXFO FTB-8510B Guia Del Usuario página 822

OTN Tabs
ODU TCM TX
Error Injection
Allows manual or automated error injection.
Type: The following error types are available with both manual and
automated injection mode: TCMi-BIP-8, and TCMi-BEI. The default
setting is TCMi-BIP-8.
Amount: Select the amount of errors to be generated.
Choices are 1 through 50. The default setting is 1.
Send button: Press Send to manually generate error(s) according to
the Error Type and the Amount of Errors selected.
Rate: Press Rate field to select the injection rate for the selected error.
The rate must be within the minimum and maximum values specified.
The default setting is 6.5E-05.
Continuous: Generates the selected error to its theoretical maximum
rate when the Continuous check box is selected. The Continuous
check box is cleared by default.
On/Off button: The On/Off button is used to activate/deactivate the
selected automated error at the rate specified or continuously when
continuous is enabled. This setting is disabled (Off) by default.
Note: "i" is the level (1 to 6) of the selected TCM.
172
FTB-8100 Series Transport Blazer