Weber Legi-Air 2050 Traduccion De Las Instrucciones página 135

Chapter 9 Troubleshooting
Problem
The desired product cycle rate
is not attained by the labeller.
The labeller performs a label-
ling without an apparent rea-
son.
No label feed possible
Labels are not
properly from the tamp pad
Labels are printed out nonstop.
Poor print quality.
Version: 24.05.2016
POSSIBLE REASON
The application
moves too slow.
The printing process is too
slow.
Sensors for the product ac-
quisition are loose, vibrate, or
are influenced by reflections
from the product surface
Loose cable connections.
Home position sensor is
misaligned or defective.
also see "No automatic func-
tion sequence possible."
Page 64
blown off Quick switch valve
(297000024) defective.
Optional proximity sensor
switches too early or not at
all.
The blow-off valve does not
work correctly.
Missing
through an incorrect parame-
terization of the print module.
Wrong printer setup or wrong
print material, contaminants
on the printer
Page 65 of 68
Solution
cylinder Optimize the throttle setting of
the cylinder, if necessary re-
quest a service technician
through our service hotline (see
page 6)
Check whether the maximum
print speed is set. Check the
optimization options for the data
processing (e.g. masks on
memory card, avoid true-type
fonts). Please refer to the print-
er manual for this.
Check the sensor settings. If
necessary, request a service
technician through the service
hotline (see page 6)
Check all connections on the
labeller.
Readjust the sensor, replace if
necessary or request a service
technician through the service
hotline (see page 6).
Check and replace part if nec-
essary.
Check or renew the sensor
(comp. to the manufacturer's
instructions).
Check valve, clean and replace
if necessary.
synchronization Compare the settings using the
printer manual and the new
system checklist.
Check the instructions of the
printer manual.
40037053 BTA Legi-Air 2050
.
.
ML-GB
DE
GB
FR
NL