EXFO FTB-8510B Guia Del Usuario página 678

Introducing and Using the Graphical User Interface
Starting the FTB-8100 Series Transport Blazer Application
4. This step applies to the FTB-8120NGE/FTB-8130NGE module only. The
Network Analyzer allows to either run the SONET/SDH or the Packet
Analyzer. Both analyzers cannot run simultaneously. Press
SONET/SDH Analyzer to start the module for SONET/SDH/OTN test.
Note: Refer to the Ethernet and Fibre Channel Application user guide for more
information on Packet Analyzer.
The exit button ( X ) closes the Network Analyzer, SONET/SDH
Analyzer, and/or Packet Analyzer applications. If a test is created, one
of the following confirmation messages is displayed, based on the
standalone feature status (enabled or not). Refer to the FTB-500 user
guide for more information on the standalone feature.
28
The following message is displayed when exiting the GUI while a
test is created and standalone is disabled.
Are you sure you want to exit the Network Anlyzer, SONET/SDH
Analyzer, and Packet Analyzer? Any unsaved information will be
lost.
The following message is displayed when exiting the GUI while a
test is created and standalone is enabled.
Exiting the application will maintain the module alive as the
Standalone mode is enabled. Are you sure you want to exit?
FTB-8100 Series Transport Blazer