EXFO FTB-8510B Guia Del Usuario página 684

Introducing and Using the Graphical User Interface
Main Window
Exit
For FTB-8105, FTB-8115, FTB-8120, FTB-8120NG, FTB-8130, FTB-8130NG,
and FTB-8140: The exit button ( X ) closes the current application. If a test
is created, one of the following confirmation messages is displayed, based
on the standalone feature status (enabled or not). Refer to the FTB-500
user guide for more information on the standalone feature.
The following message is displayed when exiting the GUI while a test is
created and standalone is disabled.
Are you sure you want to exit the FTB-8100 Series Transport
Blazer? Any unsaved information will be lost.
The following message is displayed when exiting the GUI while a test is
created and standalone is enabled.
Exiting the application will maintain the module alive as the
Standalone mode is enabled. Are you sure you want to exit?
For FTB-8120NGE, and FTB-8130NGE: The exit button ( X ) switches from
the current application to the Network Analyzer application. If the test is
running, a user confirmation is required to stop the test before switching
the application. The swiching puts the application in idle mode meaning
that the test case configuration is kept and will be recovered when
returning to that application.
34
FTB-8100 Series Transport Blazer