EXFO FTB-8510B Guia Del Usuario página 688

Introducing and Using the Graphical User Interface
Global Test Status and Controls
Button
Indicates that the laser control is on. Pressing this button will turn off the laser.
This button is only available for optical interfaces. The laser is On by default
when the test is created unless otherwise set from the Default Test Preferences
on page 530. The laser control button is not affected when turning off the laser
by generating a LOS for example.
Provides access to 10 default or customer defined test case configurations. See
Favorites on page 40 for more information.
Allows the detection of the Line Coding, Framing, and Test Pattern of the
selected DS1 or DS3 input signal once the test is created. Upon detection of
specific alarms, the detection may not be possible, press Retry to invoke the
detection again.
a. Only available when the test is running.
b. Only available when the test is not running (Stop).
Remote Status
Indicates whether the remote control feature is enabled/disabled and
indicates the number of connections established with the FTB-8100 Series
when enabled.
38
b
Indicates that the remote control feature is disabled. Refer to the
FTB-500 user guide for more information on how to enable it.
Indicates that a single connection is established with the FTB-8100
Series. The connection can be either local (on the FTB-500) or
remote (on a remote PC using Visual Guardian Lite).
Indicates that at least two connections are established with the
FTB-8100 Series. Connections can be a combination of one local
(on the FTB-500) and at least one remote connection (on a
remote PC using Visual Guardian Lite), two or more remote
connections.
Description
b
FTB-8100 Series Transport Blazer