Physical Interfaces and LEDs
Clock Interface Connections
Clock Interface Connections
AUX port: The FTB-8100 Series provides one connector, labeled AUX,
that can be used either for DS1 (1.5M)/E1 (2M)/2 MHz external clock
synchronization signal or as the second RX port for Dual RX (DS1 or
DS3) testing (FTB-8105/15/20/30). This port is unidirectional and can be
used either for input or output. Connector type is BNC for coaxial
75-ohm cable connection. An adapter cable (BNC to Bantam) is
required for Bantam connection (not supplied).
REF OUT port: The FTB-8130/FTB-8130NG/FTB-8130NGE/FTB-8140
provides one connector, labeled REF OUT, that can be used for the
following clock signals. Connector type is SMA.
For OC-192/STM-64/OTU2/OTU1e/OTU2e/OTU1f/OTU2f
Clock
OC-192/
divider
STM-64
16
622.08 MHz 669.33 MHz 690.57 MHz 693.48 MHz 704.38 MHz 707.35 MHz
32
311.04 MHz 334.66 MHz 345.29 MHz 346.74 MHz 352.19 MHz 353.68 MHz
64
155.52 MHz 167.33 MHz 172.64 MHz 173.37 MHz 176.10 MHz 176.84 MHz
For OC-768/STM-256/OTU3
2488.3 MHz
22
Output frequency for
OTU2
OTU1e
Output frequency for
OC-768/STM-256
OTU2e
OTU1f
Output frequency for OTU3
2688.7 MHz
FTB-8100 Series Transport Blazer
OTU2f