Publicidad
Ï Fasten the wire harness, TPS
lead (in the wire harness),
starter motor lead and negative
battery lead to the frame with a
plastic locking tie and cut off
the tie end.
Ì Make sure that the TPS cou-
pler does not go out the chas-
sis.
Ó Fasten the TPS lead to the
frame with a plastic band.
È Fasten the neutral switch lead
and oil hose together with the
plastic locking ties and cut off
the tie ends.
Ô Pass
the
cylinder
breather hose through the
hose holders.
All manuals and user guides at all-guides.com
CABLE ROUTING DIAGRAM
Fasten the neutral switch lead
to the frame with a plastic band
ends outward.
Ò Fasten the neutral switch lead
and AC magneto lead to the
frame with a plastic band ends
outward.
˜ Pass
the
breather hose on the outside of
the radiator hose 1 and on the
inside of the radiator pipe (radi-
ator hose 4).
ˆ Pass the oil tank breather hose
on the outside of the AC mag-
neto lead, neutral switch lead,
head
wire harness and cylinder head
breather hose.
2 - 24
Ø Pass the wire harness on the
outside of the neutral switch
lead and AC magneto lead.
∏ Fit the brake hose into the
guides on the protector.
ΠPass the wire harness through
the cable guide.
 Fasten the AC magneto lead
cylinder
head
and neutral switch lead to the
cable guide at their protecting
tube with a plastic locking tie
and cut off the tie end.
Í Pass the carburetor breather
hoses, overflow hose and cool-
ant reservoir tank breather
hose so that the hoses do not
contact
absorber.
SPEC
the
rear
shock
Publicidad
Capítulos
